When you assign instruction, it will default to Instructional Mode. This means that the students will proceed through the assignment and unit components in order and cannot skip around. The instructional mode is the recommended mode for most assignments. In some cases, you may want to allow the student to navigate to any unit and any component within that unit to give them additional practice opportunities. To allow this functionality, you can change the assignment to Manual Mode.  

1) From the Classes Tab, click on the class that contains the assignment.Locate the specific assignment on the Instruction Sub Tab

2) To change the mode for everyone that has the assignment, click on the 

in the mode column next to the name of the assignment to change it to an 

To change the mode for specific students, expand the assignment by clicking on the + symbol beside the assignment name. Then in the mode column click on the 

beside the specific student(s) to change it to an 

3) Click Save.

Did this answer your question?